You are here

HJ

Holden HJ Monaro inner door wire plastic nut/screw

I'm looking for the plastic nut that screws onto the inner rod wire that allows the door to open using the outside door handle.It pushes down on the door lock.
Does any one know what they are called and where i could purchase one from.

See photos attached

Cheers
Paul

Model: 
Topic: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

HOLDEN HJ ORIGINAL BODY PROTECTOR MOULDS HELP PLEASE

Hi everyone hope you all are well.I need some help please.i got a holden hj station wagon with original body protector moulds need some advice on taking them off step by step with out damaging them.Thankyou

Model: 
Topic: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Anyone had a HQ-HZ rear windscreen fitted in Melbourne recently?

..if so, where'd you get it!

Had the rear windscreen blow out on the GTS (HJ Sedan) a couple weekends ago, while underneath it playing with the diff.
Ignoring how surprised I was (never heard of this happening..!), I was a little more surprised later when I struggled to get a replacement screen. O'brien and 2 or 3 other places haven't been able to help.
I'd had a generic aftermarket F&R screen fitted in ~2008, and at the time it wasn't even remotely a problem. But now? Supposedly everyone's all out of replacement rear screens!

Model: 
Topic: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

HELP

Hi all, i have owned my hj GTS sedan for almost 20 years but its true identity has always been a mystery.The car was stolen long before i purchased it and all compliance plates were removed.After much research and with engine and chassis numbers only i find myself at dead end after dead end. If anyone could help as to identifying the car by engine and chassis numbers only that would be great.Any other info on GTS identification would also be appreciated.

Chassis no. BHJ56673S

Engine no. QT888009

Cheers....

Model: 
Topic: 
Engine: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Hei

G'Day Fellas,
Well after spending all that time on the HEI Dizzy. Had same problem today.
the oil wont make its way up the shaft. Anyways I have a Mallory dual point dizzy I can swap over.
My questions are, Firstly can I hook-up the Standard coil directly from the relay or do I need to use the yellow wire. ( I do have a ceramic ballast resister).

Secondly, can I use the HEI spark plugs and just reduce the gap, or should I buy standard plugs.

Thanks, and I will have a closer look at that HEI dizzy when I get a chance.

Model: 
Topic: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

My molecrafts

Image: 
Model: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Hydro8

Image: 
Model: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Fans of the mighty 6

  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

HEI Ignition Problem

G'Day Fellas,

Model: 
Topic: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

202 cam choice?

G'day all. Bin a while since I was here last, lost all interest in computering... too much to do elsewhere.

Model: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Sale of the century apparently

  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Holden HJ 1975 Engines

Hi guys
Just want to know if the Holden Kingswood HJ 1975 model ever came out with V8 Chevy engines
Thankyou Shelly

Model: 
Topic: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Bad 308 intake gasket?

Hi guys,

After converting my 202 to a 308 and trying to get this beast to fire up and start I've noticed a few things.

When I start it it can be hard to start (Have to pump the accelerator a few times and then open the throttle to start it while cranking)

When I finally get it to idle the motor will then briefly surge and have a rough idle.

White smoke is blowing out of the exhaust manifold and a little from the rocker cover.

Oil on dipstick is slightly milky.

So I'm thinking either head gasket or intake manifold gasket.

Model: 
Topic: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Nice van at shops today

Had a yarn to the owner nice bloke too, he may get on here one day and say gooday.

Image: 
Model: 
Topic: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

OK Al I'll see your Q wagon

And raise it with a J wagon, at the Goldy mind you.

Image: 
Model: 
Topic: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

HJ Holden Bench Seat covering kit

Hi There
We are looking for a company that would have the patterns to make up a bench seat cover that we can give to our local upholster to have fitted.
We have collected a bench seat out of a HZ ute. Our upholster is repairing the springs, foam and base etc and said to shop around to see if someone has a pattern and can make up a covering kit that he can then fit. Our seat had no material left on it at all, so therefore we don't have a pattern to work from.
Any help from anyone would be very much appreciated.

Thanks and Kind Regards

Model: 
Topic: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

what a trip

Image: 

What a trip. 3days and over 1200 key doing the Chrissy thing seeing the family in my HJ PREM from Cairns to Port Douglas up to Mareeba on the Atherton tablelands down to Innisfail to Townsville and than back home. Not only with the wife and kids but with our old Holden and all went well, well it did rain ha ha.
A couple of years ago i got one of those wiper motors from castle rod shop with the conversion kit. as i live in NTH QLD it rains a bit ha ha, we can get 100mm in a 12 hour.
This wiper motor got a work out and NEVER MIST A BEAT.
"IF your going to replace yours, than this is the G O"
This was taken when we got home. and had a quick bath and is now put to bed ha ha (my wife yells,"don't forget to give it a hug and kiss goodnight")

Model: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Paint code for hj kingswood

Looking for info on what colour my new wagon is top is white 568- 15951 bottom is 568-15952

Topic: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Quadrajet auto choke stuck on full

My newly rebuilt quarajet's choke seems too stay on from start up (runs super fast)
, then never backs off again once warm.
Drove it 30 mins & still running fast (choke)
Tried adjusting it, but that wont even back off the idling speed... am i missing something?

Image: 
Model: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Merry christmas to all

Image: 

Just short note to say a big THANK YOU for all the advice and help from all, and to wish all my fellow "Old Holden" clubbers a Very Merry Christmas and a Happy and SAFE new year to all out there and drive safe please.
Regards from Triple D family,
Darren,Annette,Mikey,Sabrina

Model: 
Topic: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Pages