Skip navigation.
Home

Home

In need of some help !

Submitted by Holden Fan (not verified) on Tue, 09/09/2008 - 06:09.

Hey i have a 4 door LJ TORANA and recently bought a rare spares door rubber kit just wondering how ur suppose to get it back into that lil groove around the whole door doesnt seem to want to stay in there.. is there are a special tool or something?

any help would b great

thanks
shayne

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.

lil groove on door seal

   Verdoro70 on Tue, 16/09/2008 - 22:25.

Hi - just saw your post. These things are *Naughty potty word* to get in there properly. I did 3 doors late last year. The only way I found was to tip the seal so one edge fitted under the groove lip, then use a blunt small screwdriver to lever the other side in being careful not to poke a hole in it. Then push down along the length to help the rubber fit right in to the groove, and finally lift up the rubber to check that the first edge was still in the groove and poke it back in if it wasn't. I hope that helps. Be prepared for lots of swearing and sore hands.
Good luck, Clive.

»


Post new comment

  • Allowed HTML tags: <a> <strike> <blink> <i> <u> <br> <b>
  • Easily link to terms in various wikis. For help, see <a href="/interwiki/1">interwiki</a>.
  • Web page addresses and e-mail addresses turn into links automatically.

  • Links to specified hosts will have a rel="nofollow" added to them.

  • Lines and paragraphs break automatically.
  • Filtered words will be replaced with the filtered version of the word.

More information about formatting options

Captcha
This question is used to make sure you are a human visitor and to prevent spam submissions.
Copy the characters (respecting upper/lower case) from the image.