You are here

Holden H series fuse holder parts

Does any one manufacture new components to replace the rusty fuse holders that cause higher electrical drain on wiring .
2 wires on this board have cooked the insulation on. could have led to a fire. I do not wish for a modern blade replacement .

Model: 
Topic: 
Section: 
AttachmentSize
Image icon 20190725_155231[1].jpg3.51 MB

Comments

I don't know if they are still available. I'm thinking you could use a generic SFE PCB mounted fuse clip and solder the wires direct to the back, some have tangs that should lock into the fuse board. Otherwise you could buy a second hand fuse board and salvage the best parts - even dismantle yours and give the clips a good clean up with emery paper or similar...some electrical contact cleaner- or wd40..You may be able to clean them up quite well

  • Like0
  • no like0
  • Holdenpaedia idea1
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Andrew

  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.