You are here

Home

HQ Coupe roof strip

published by moppocars on Thu, 18/07/2019 - 09:24

Hi I am wondering if anybody can help me with some information about this strip that I have pictured for my HQ Coupe
I know that it screws to the roof of my car but these strips had silicon all over them and I am wondering does this need to be applied to the strip before I screw them on also is there a rubber in my kit that I should fit prior to fitting them on.

Les

Model: 
HQ
Topic: 
General
Engine: 
308
Section: 
Body
AttachmentSize
Image icon 23F1BDD7-6581-4FA4-B993-4FF3A0E3F8F2.jpeg3.9 MB

Comments

Submitted by Holden Owner on Thu, 18/07/2019 - 12:52.

i doubt it would have silicone from the factory
most likely had mastic sealer on the side that touches the body

  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Submitted by moppocars on Thu, 18/07/2019 - 15:16.

RH had it. LH didn’t have it
So do put something in there

  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Submitted by Holden Owner on Fri, 19/07/2019 - 00:17.

i would put mastic on both to seal out any water getting under the strip
possibly a thin line of mastic down the centre would be enough

  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny1
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.