You are here

Tailshaft lengths

I searching for a tailshaft to suit my modified fc ute its running trimatic and vp commodore diff. Looking for a tailshaft thats 1210mm center to center of the uni's
Cheers Glenn

Model: 
Engine: 
Section: 

Comments

Just have it made. I had to lengthen mine when I put the v8 in. It cost me $500 with new uni's and yoke. Find a tail shaft mob and give them your measurements and they will make one to suit. You may have to give them your old one for the ends.

  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

There are plenty of shops that will make a tailshaft. It would be nothing short of a miracle to find one for your application. You only need to measure from the back of the trans rear seal, to the face of the diff yoke. If you are in Melbourne try Duggans, http://www.dugganbal... They were like half the price of the next joint I tried, and have had zero problems with it.

  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.