I am after a standard Air Cleaner for a HZ 253 with a Rochester Carby. Does anyone have one for sale? I am in Northern NSW near Tweed Heads!

Very happy with the paint I just put on a Mates Corvette considering it's Acrylic Lacquer done in his in his Garage.

5 coats of color, 2x color and clear and 2x straight clear. He just finished rubbing it back with 2000 and buffing it.

No the white dots in the photos are not in the paint, just a dusty camera lens.

He bought it over in the States earlier this year, and now it is up for sale (after it all goes back together). The original paint wasn't too bad, but he is real fussy about having things looking 'shmick' (which is a good thing).

Next job is a 65 and a 66 Mustang (I know they are only Fords) he brought over also to get the same treatment!

Will the P7210 Master Cylinder work on a HZ with Disc front and Drum Rear?

I have one to fit, but all the info I can find says it is for HQ and HJ only?

Will a HZ GTS Speedo fit into a standard HZ dash (replace the standard speedo).

I want to do this so I have a trip meter (which the standard speedo does not).

Cheers
Peter

I am after a standard HZ Clock. Must be working (see attachment for type of clock I need).

Email me at: rastas4@aapt.net.au

Cheers
Peter

Does anyone have a decent Electronic V8 Dizzy & Coil for sale at all, or alternatively are any on those new ones on 'Evilbay' any good?

Cheers
Peter

Does anyone know where I can get four 45mm diameter Holden Lion type decals for GTS wheel centre caps at all?

I have tried 'fleabay' with no luck???

Can anyone tell me or have a picture of where the wire goes from the horn contact spade connector at the base of a GTS steering wheel?

I am guessing it connects to somewhere on the spring loaded plate the horn pad screws to???

Just added a dual exhaust and GTS Rims to the new baby. I'll leave it at that now as I reckon it looks pretty neat? (just gotta get some centre caps for the rims though)!

Anyone have a full set of HQ- HX GTS Rims for sale near Northern NSW (Tweed Area)/ Gold Coast at all?

Email: rastas4@aapt.net.au

Cheers
Peter

I'm after a reasonably priced GTS Steering Wheel for HZ (intact with no breaks).

I'm in Northern NSW near Tweed Heads if you are willing to post?

Does anyone know the paint code for the Grey dashboard on a FB at all???

I am after a clean/ rust free V8 HZ to HQ Sedan (T Bar Auto & Power Steer) with all the work already done (getting lazy in my old age). Car will be used on Club outings etc.

Looking to spend no more than $9000.

I am located in Northern NSW just South of the Gold Coast.

Email: rastas4@aapt.net.au

Cheers
Peter

Thanks Guys.

I've had a heap of replies for Statesmans, but definitely want a Kingswood or Premier only!

Cheers Again

Peter

Anyone know where I can get 2x new brake lines for a UC Torana with Girlock Calipers and the Copper Washers that go with them where line bolts on to the Calipers?

Cheers

Ok. A mate of mine has given me a pair of HR Disc Brake Stub axles (decided to go this way as I already have the VH40). I have a UC Torana that I have just rem removed the Calipers and discs from.
I noticed that the HR Disc Stubs have screw threads tapped in the 2 lower bolt holes where the backing plate for the disc attaches where the Torana didn't (the bolts went straight through and attached at the back). Also, the HR Stubs have a fine thread where the 'Caliper backing Plate' attaches to it, where the Torana has a coarse thread?

Sorry if this is a little confusing Guys, but I wanted to make sure that these are definitely HR stubs I have been given, and that the existing bolts on my HR Drum Brake front end are going to fit?

Has anyone got info on this?

Cheers
Peter

Can someone tell me if I can fit a VH40 Booster (I have a recoe'd one here) to a 4 wheel drum brake HR?

I know you can use the VH44, but having the VH40 already makes life (and the wallet) a little easier!

Complete 4 door 4 cyl sedan (Sunbird Deluxe) except 2x wheels (I have 2x EH rims with tyres to get it onto your trailer. It does have rust (guards, bootlid, bonnet are good), doors are repairable, motor runs, gearbox works as do all lights etc. It has the Rubber Overiders on the front Bumper only and SLR Hubcaps.

Will not separate. $250 (I Need the ROOM)

Located Northern NSW near Tweed Heads.

Phone Peter 0266777525 or Email rastas4@aapt.net.au

Complete 4 door 4 cyl sedan (Sunbird Deluxe) except 2x wheels (I have 2x EH rims with tyres to get it onto your trailer. It does have rust (guards, bootlid, bonnet are good), doors are repairable, motor runs, gearbox works as do all lights etc. It has the Rubber Overiders on the front Bumper only and SLR Hubcaps.

Will not separate. $250 (I Need the ROOM)

Located Northern NSW near Tweed Heads.

Phone Peter 0266777525 or Email rastas4@aapt.net.au