You are here

Archive - Feb 4, 2018

T56 behind 308 Hz

Hi everyone
I’m in the motion of converting my hz sedan 308 and putting a t56 manual in
Has anyone done this conversion? And if so any pics to help todo with tunnel mod and tail shaft height
Iv purchased a cross member and bell housing from castle main but need more info before I cut the tunnel
Cheers

Model: 
Engine: 
Section: 
  • Like1
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Hz 308 t56 conversion

Hi everyone
I’m in the motion of converting my hz sedan 308 and putting a t56 manual in
Has anyone done this conversion? And if so any pics to help todo with tunnel mod and tail shaft hieght
Iv purchased a cross meme bet and bell housing from castle main but need more info before I cut the tunnel
Cheers

Model: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Well, that was poo.

I got up at 5:30 to watch the first couple of hours of the Bathurst twelve hour then I saw bits of it between jobs around the house.
I sat down at 5 to watch the end and it looked like being a bit of a cliiffhanger.
With 20 minutes to go:
The lead car was an R8. The team thought it didn't have enough fuel to finish and they couldn't re-fuel without losing the lead, so they decided to go for it.
The second car was and AMG GT. It had maybe a cupful more fuel than the Audi.
The third and fourth cars were both Porsches and they had no fuel worries.

Topic: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

HX Lookalike

Here (5:40) ...

https://www.youtube....

Model: 
Section: 
  • Like1
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Resetting iac valve on vt v6 ecotec motor

Pindle fell out so reset to 27mm now need to know the correct procedure To reset the iac valve to the engine

  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.