You are here

Sale/Wanted

Hg holden windscreen visor for sale?

Not sure if we can post this on the main page but i have a sun visor i just pulled off my 71 hg Kingswood. Has some surface rust but is solid. Has both brackets clips and the 4 bullet type nuts.

Whats it worth..

And if anyones interested message me on 0487375380

South east qld

Have a good week guys n gals.

Simon

Model: 
Topic: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Wanted to buy - HJ - HZ windowless van body or complete van

Just putting the feelers out to see what is around for sale. I am looking for a HJ to HZ windowless van (must be original windowless not welded up side panels) Can be rolling body or complete van but must be good solid body that requires as little work as possible. Please phone 0404 237 690 if you have something that you think may be of interest.

Model: 
Topic: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Grey motor fuel/vacuum pump

Hello, I'm looking for a fuel/vacuum pump for a grey motor.

Model: 
Topic: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Grey motor fuel/vacuum pump

Hello, I'm looking for a fuel/vacuum pump for a grey motor.

Model: 
Topic: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

VK 3.3 Recon'd Long motor for sale, Perth (VK Sump)

Hey guys, I have for sale a new Recon 3.3 Black motor, heads set up for gas. Located in Perth
I needed a new donk for the pig, which I purchased from an engine builders in Warrnambool, VIC. Lo and Behold, I bought both off the fella, as freight was an easy setup.

I've set mine up for the HQ, and have the other sitting here, hoping for a good home (Otherwise I'll move it to Sydney with me in December).

If you're genuinely interested, you can email me at nstyhj@gmail.com

Model: 
Topic: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Hktg south African chevrolet ss front.

As the title says.

How hard are these front ends to find?

Model: 
Topic: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

For Sale - heaps of FX - FJ parts some new old stock

Hi all, I have sold my FJ and have been clearing out the shed. I have heaps of FX - FJ parts (mostly FJ) for sale including a complete rubber kit for van or ute. Also have reco original water pumps and kits. Too many parts to list, if you are looking for something flick me a message. I only get on the computer once a day so please be patient.

Model: 
Topic: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

15K

Now where have l seen this beforehand

Image: 
Model: 
Topic: 
  • Like1
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Rebuilt blue or black 202

Hey guys, I'm chasing a blue or black recon 3.3 for the kingswood daily driver, in the Perth region. I need to do the rings on my current engine, and I simply don't have the time.
Can anybody recommend a mob that might have an exchange on the shelf?? Otherwise I'm up for freighting one I saw in Melbourne.

Thanks for any and all help
Rhys

Model: 
Topic: 
Engine: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

HR HD panel vans for sale

In Logan near Brisbane $250 the pair.
Call the owner 0409 242 248

Model: 
Topic: 
Engine: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Vs taillights WTB

I'm chasing a set of VS SEDAN taillights. If any one has a set and is willing to post if I can't pickup in the Melbourne area. Let me know please. Thanks. $40-$60

Topic: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

vacuum wipers, 1950 ford, F1

The motor works when I install one vacuum line, it has 2 nipples
Have not figured out what the other nipple is ..

Topic: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Plastic Grommets

Hello i have two plastic push in grommets 1"ON my Hq tonner. These 2 grommets are in the chassis in the crossmember at the back of the cab. These grommets go in the holes the handbrake cable runs through. I want to replace these in the chassis,i am rebuilding. I cannot find any anywhere. Does anyone know where to find replacement ones.
Regards
Onetonman

Model: 
Topic: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Pig Oinks 308

Asked earlier about centre caps WTB to fit 68mm centre bore, preferably screw on. Read Pigs article on polishing rims, helped heaps. My question, where did you buy your centre caps back then Pig and still interested if anyone out there has some to sell, consider clip ons.
Thanks again, Arch.

Model: 
Topic: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

HQ -WB STEERING COUPLING

Hello all i am after a cheep steering coupling for a HQ-WB . Can be in any condition.

Model: 
Topic: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Centre caps πŸ˜’

Can anyone help out with tidy, used caps to suit? 2 rims have holes drilled for screw on, 2 push on, prefer screw on type if lucky. Thanks in advance, Arch.

Image: 
Model: 
Topic: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Hq factory air conditioning vent tubing

Hello i am after someone who has the under dash vent tubes for a HQ Statesman. I need the center distribution box and the pipe across to the drivers air vent. I just want to borrow them to make a fibreglass mould. As they are so hard to find . I had a set i lost in a business closure. It makes it hard. Any help appreciated.
Regards
Onetonman

Model: 
Topic: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

EH crasg box wanted

A mate is after a crash box from an early 149 EH (EJ bellhousing bolt pattern) or later EH-HK box with bellhousing.
He has to recondition a box for a customer's EH so any gearbox with good gears and selectors would be OK. Second gear in the customer's gearbox is past it, and possibly the selector.
Possibly an EJ box even so he could build one from the two.
Preferably reasonably close to Port Macquarie, NSW but anything considered.
Phone David (not me) on (02)6559 9167 during business hours.
David (Not signed in)

Model: 
Topic: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

EH generator wanted

Does anyone have an EH generator for sale? A bloke asked Nathan if he knew where he could get one.
I suggested an alternator conversion but apparently the bloke wants to keep his EH original.
David

Model: 
Topic: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny0
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Wanted to buy

Looking to buy a 186k or 186 X2 Holden HR Premier engine

Model: 
Topic: 
Engine: 
Section: 
  • Like0
  • no like0
  • Holdenpaedia idea0
  • Funny2
  • Wrong Category0
Please use, Holdenpaedia will get the first box on the left side. Post any suggestions.

Pages